Troubleshooting; Before You Send In The Appliance; Spare Parts And Accessories; Warranty - Dirt Devil M5083 EQU Silence MC Bedienungsanleitung

M5083.book Seite 17 Dienstag, 9. Oktober 2012 9:55 09

6 Troubleshooting

6.1 Before you send in the appliance

6 Troubleshooting
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the
appliance and disconnect it from the mains before starting troubleshoot-
ing Chapter 4.3, "Switching off".
Problem
The appliance appears to The bypass vent (Fig. 1/18) is open.
work properly, but the
The attached nozzle is unsuitable.
cleaning result is poor.
The position of the 'carpet/hard floor' selec-
tor (Fig. 1/2) is unsuitable.
The dust container is full.
Nozzle, telescopic tube or suction hose is
blocked.
The filter is dirty.
The vacuum cleaner sud- The overheating protection has tripped
denly switches off. (possibly due to blocked suction channels,
dirty filters, etc.).
NOTE:
If you cannot solve the problem following these instructions, contact our customer services (contact Page 56, "International Service").

6.2 Spare parts and accessories

Item number Description
5080001 Dual motor protection filter consisting of:
1 foam plastic filter element and 1 filter holder
5080002 1 hygienic exhaust filter
M203 1 parquet brush
M223 1 wide "Fello" turbo brush
M232 1 long, flexible crevice nozzle

6.3 Warranty

The statutory warranty regulations in accordance with the EU Directive
1999/44/EC apply.
Before contacting your authorised Royal dealer, Royal service partner or
appliance market or sending in the appliance, first follow the procedure in
the following table to check if you can solve the problem yourself.
Possible cause
Close the bypass vent (Fig. 1/18).
Change the nozzle, Chapter 3.2, "Selecting the proper nozzle".
Set the "carpet/hard floor" selector (Fig. 1/2) to the correct position for the
type of floor, Chapter 4.2, "Vacuum cleaning", step 4.
Empty the dust container, Chapter 5.1, "Emptying the dust container".
Remove the obstacle. If necessary, use a long wooden stick (e.g. a broom-
stick) to do this.
Clean the respective filter, Chapter 5.3, "Cleaning the dual motor protection
filter" or Chapter 5.4, "Cleaning the hygienic exhaust filter".
Switch off the appliance and unplug it from the power outlet socket. Eliminate
the cause of overheating (e.g. by disassembling the telescopic extension
tube and the flexible hose and removing the blockage, and/or by cleaning the
filters). Wait for about 45 minutes. After the appliance has cooled down, you
may switch it on again.
ATTENTION:
Only use original spare parts from the scope of delivery or those that you
have purchased by reordering.
You can order these spare parts:
Contact data: Page 56, "International Service"

Further information:  www.dirtdevil.de

In non-EU countries the minimum requirements of the warranty in the re-
spective country apply.
Page 56, "International Service"
Solution
17