Description Of The Machine; Noise Emission; Content Of Delivery; Transport And Installation - Jet JDP-370 Gebrauchsanleitung

Mains 230V ~1L/N/PE 50Hz
Output power 0.55 kW (0.75 HP) S1
Reference current
Extension cord (H07RN-F) 3x1.5mm²
Installation fuse protection
Mains 400V ~3L/PE 50Hz
Output power 0.55 kW (0.75 HP) S1
Reference current
Extension cord (H07RN-F) 4x1.5mm²
Installation fuse protection

4.2 Noise emission

(Inspection tolerance 4 dB)
Acoustic pressure level
(according to EN ISO 11202):
Idling LpA 69,6 dB(A)
In operation LpA 79,0 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.

4.3 Content of delivery

Machine base
Column and bracket assembly
Head assembly
Table
Table bracket lock handle
Table rising handle
3 down feed handles
16mm keyless chuck, B18
MT-2 / B18 arbour
Chuck guard
Drift key
Operating tools
Assembly kit
Operating manual
Spare parts list.

4.4 Description of the machine

6.2 A
10A
3 A
10A
A......Pulley cover
B.....V-belt tensioning
C....Down feed handles
D....Motor
E....Table rising handle
F....Base
G....Table lock handle
H....Working table
I.....Chuck guard
J....Drill chuck
K....Depth stop
L....ON / OFF Switch
5. Transport and start up

5.1 Transport and installation

The machine is designed to operate in
closed rooms and must be placed
stable on a firm and levelled table
surface.
The machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent e.g. petroleum.
(Note: lacquer thinner or similar can
destroy the paint).
Fig 1
5
Attach the column assembly (Q, Fig.
2) to the base (F) with four hex cap
bolts (R), tighten firmly.
Fig 2
Attach the column flange (P, Fig 3)
with the rack (O) installed to the
column.
Mount the rack guide ring (N, Fig 2)
and clamp with the screw.
Slide the table bracket rising handle
(E, Fig 3) onto the table bracket shaft.
Fig 3
Turn the handle until the set screw is
opposite the flat section on the shaft
and tighten the set screw (T).
Screw the lock handle (S, Fig 4) into
the column flange (P).