Disassembly Of Glass Pane In Door; Assembly Of Glass Pane In Door - Dik Geurts Jannik Medium Low EA Installationsvorschrift

IN S T A LLA TION M A NU A L

9.5.1.3 Disassembly of glass pane in door

• Avoid damage when removing/fitting the glass pane.
!Caution
• Avoid/remove fingerprints on the glass pane(s) as they will burn into the glass.
Use the supplied glass pane cleaner to remove fingerprints from the glass pane(s).
!Tip
To remove the glass pane in the door, please follow the instructions below (see Appendix 2, fig. 8):
Ø
Open the door.
Ø
Lift out the door by sliding it upwards.
Ø
Place the door on a flat surface.
Ø
Unscrew the nuts on the inside of the door.
Ø
Remove the frame and tape of the door seal.
Ø
Lift out the glass pane. The pane seal is also taken out.

9.5.1.4 Assembly of glass pane in door

Assemble the glass pane in the door according to the steps described in paragraph 9.5.1.3. 'Disassembly of glass
pane in door', only in reverse order.
• Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.
!Caution
• Place the glass pane (including new pane seal) with the logo to the bottom right.
• Place a new door seal.
• Connect both ends of the heat resistant tape at the door seal.
Make sure this connection of heat resistant tape is placed at the bottom of the glass pane.
!Caution
39