Guarantee; Possible Faults; Technical Data; Description Of Device / Spare Parts - ATIKA BWS 400 Originalbetriebsanleitung

Guarantee

Please observe the enclosed terms of guarantee.

Possible faults

Before each fault elimination:
− Switch off device
− Wait unitl the saw comes to a stop
−
Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switching on
Machine stops while cutting
Burned spots at the cut areas
Saw vibrates
Recuperating mechanism of the jigging
device does not work
Decelaration too slow (time to dead stop
>10 sec.)

Technical data

Type
Motor rating P
1
Mains voltage
Mains frequency
No-load speed n
0
Mains fuse
Protection class
carbide tipped saw blade maximal
Saw blade location hole
Number of teeth
Saw blade thickness
Cut width
max. cutting capacity
Dimensions (length x breadth x height)
Weight (N.W.)

Description of device / spare parts

Pos. Order-No. Denomination
1 Pre-assembled device unit
2 Brace
3 Motor P
4 Switch
5 Jigging device
6 Recuperating bolt
7 Saw blade cover
8 Chain
9 Securing cotter pin
10 Recuperating spring
12 Safety chain
13 Saw blade casing
14 Front saw blade flange
14
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Saw blade blunt
• Feed is too great
• Saw blade blunt
• Saw blade is warped
• Saw blade not properly mounted
• Recuperating spring broken or worn out
• Recuperating bolt popped out from its bracket
• Motor brake defective
1,8 KW
1
Remedy
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Replace saw blade or have it sharpend
• Allow motor to cool and proceed working with less
pressure
• Replace saw blade or have it sharpend
• Replace saw blade or have it sharpend
• Mount saw blade properly
• Replace the recuperating spring
• Insert the recuperating bolt in its bracket and secure it
with a cotter pin
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
BWS 400
1.8 kW S6 - 40 %
230 V
50 Hz
2990 min
-1
16 A träge
IP 54
∅ 400 mm
∅ 30 mm
40
2.2 mm
3.0 mm
approx. ∅ 120 mm
860 x 940 x 1000 mm
35.5 kg
Pos. Order-No. Denomination
15
Saw blade (∅ 400mm x 3,0 x 2,2 x 30 x 40T)
16 Rear saw blade flange
17 Locking nut M 20
18 Cover
19 Handle
20 Support extension
21 Star grip knob M6x40
21A Star grip knob M6x20
22 Length stop
24 Set of plastics insert
27 Safety label
28 Slip-on foot – small
29 Slip-on foot – big