Transport; Storage; Guarantee; Possible Faults - ATIKA KGSZ 250 Bedienungsanleitung

Transport

Remove mains plug before each transport.
Before each transport:
− Position saw head vertically
− Turn rotary table to 0°
− Push saw head down and engage the transport locking
pin (17)
− Secure the pulling device!

Storage

Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly oil
Never use any grease!

Possible faults

Before each fault clearance
− Switch off device
− Wait for standstill of the saw blade
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switch-
ing on or switches off during idle
running
Motor hums but does not start
No crosscut function
Saw blade jams while cutting
Burned spots at the cut areas
Saw vibrates
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Spindle lock engaged
• Transport locking pin not removed
• Locking device for pendulum cover not
opened
• Saw blade is dull
• Feed is too great
• Saw blade is not suitable for the work step or
is dull
• Saw blade is warped
• Saw blade not properly mounted

Guarantee

We grant a guarantee of two years, commencing with the
day of delivery from the dealer's store, for material and ma-
nufacturing faults.
Warranty claims, even during the warranty period, will not be
accepted for damages due to incorrect handling or inade-
quate packaging during return of the devices or to a non-
observance of the operating instructions.
Faulty parts must be sent to our works, postage or freight
free. We reserve the right to decide upon free spare part de-
livery.
Guarantee work will be completed by us or an authorised
servicing agency. Guarantee damage can only be remedied
by another firm with our explicit approval.
The warranty does not cover normal wear and tear of: Saw
blade, table insert and carbon brushes.
Guarantee is also granted if original spare parts are used.
Subject to changes in the interest of technical progress.
Removal
• Check safety fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an ap-
proved electrician or replaced by original
spare parts
• Loosen saw blade locking device (17)
• Pull out transport locking pin (27)
• Open locking device (33)
• Replace saw blade (5)
• Allow motor to cool and proceed working with
less pressure
• Replace saw blade
• Replace saw blade
• Mount saw blade properly
25