Troubleshooting - Megasat HD510 Bedienungsanleitung

7 Troubleshooting

If you experience problems with this receiver or its installation, in the first instance
please read carefully the relevant sections of this User Manual and this Troubleshooting
section.
Problem
No picture
Screen shows
No Signal
No sound from
Speaker
Only sound,
no image on the
screen
Scrambled channel
message
Forgotten channel lock
code
No response to remote
control
The image stop
suddenly or mosaic
Possible cause
Power isn't connected
The power switch is not on
Not connect DVB-S cable
Incorrect setting
No or incorrect connection
with audio cable
Mute the sound
Incorrect sound track
No or incorrect connection
with AV cable
The program is a radio
program
Channel is scrambled
Receiver off
Handset not aimed correctly
Front panel obstructed
Remote control batteries are
inserted incorrectly
Handset batteries exhausted
The signal is too weak
What to do
Connect the power
Switch on the power
Plug in the DVB-S cable
Set up correct parameter
Connect the audio cable
correctly
Switch on the correct
volume control
Try another sound track
Connect the audio cable
correctly
Press <TV/RADIO> key to
shift into TV mode
Select an alternative channel
Re-install channels to cancel
channel lock
Plug in and turn on receiver
Aim handset at front panel
Check for obstructions
Check batteries direction
Replace remote control
Strengthen the signal
17