Seat Angle Adjustment; Armrest; Joystick Control Panel; Removing The Control Panel - Otto Bock A 200 Bedienungsanleitung

7.2 Seat Angle Adjustment

The A200 offers seat angle settings in 3 different positions (0°, 3° and 6°). For setting the position, 2 quick release
levers are used which are located at the front below the seat. To change the seat angle, loosen the two quick
release levers. Adjust the desired seat angle by simultaneously lifting the seat slightly and pushing the brackets to
the rear. Ensure that the brackets completely engage in the new position and tighten the quick release levers.
Note:
Ensure the quick release levers are snugly tightened after all seat angle adjustments!
Note:
During seat angle adjustments the user must not sit in the wheelchair.

7.3 Armrest

Remove the armrests by loosening the thumb screws at the lower end of the armrest and lifting the armrest upwards
(Fig. 10).
Both armrests can be removed, however, only the side without the control panel can be removed directly. Before
removing the armrest on the side with control panel, the joystick control panel must be removed (Fig. 11).
Figure 10
The armrest height can be changed by loosening the set screw at the upper end of the armrest holder. Ensure the
set screw is retightened after making any adjustments.
7.4 Control Panel
7.4.1 Removing the Joystick Control Panel
The joystick control panel can be removed by pulling it to the front.

7.4.2 Adaptation to the Arm Length

After loosening the attachment screws on the underside of the armrest, the control panel mounting can be adjusted
to the front or to the rear and thus adapted to the desired arm length (Fig. 12). Ensure all attachment screws are fully
tightly after adjustment.
Figure 11
Figure 12
25