General Functions; Using The Control Functions - ModelCraft 23 36 14 Bedienungsanleitung

General Functions

The following functions are general and also for sections of surface and helicopter
models. The illustration of the display on the following pages show a selected aeroplane
model. The display is very similar to a helicopter model.
The operation elements with red labels are for aeroplanes, with white labels
for helicopters.

Using the control functions

From this section you can learn how to use the control functions and how to set the ser-
vo movement as well as the central position for every control process. By pressing the
„END" button several times on the operation field, you reach the monitor listed below,
i.e. the entry monitor, which shows type and number of the present model, the PPM
modulation and the voltage of the accumulators in the transmitter.
By pressing the key „CH+/YES"- you get to the „STW" monitor. Upwards the display of the
elevator shows („CH EL"). The model number and „AERO" are displayed on the left side,
the stopwatch shows „0", because the time has not been programmed.
130
Figure 8
Figure 9