B) Operation - ModelCraft 23 36 14 Bedienungsanleitung

The package of the remote control system was exclusively developed for a safe transport
and storage of a remote control components. Do not tear the box after unpacking the
device! You should keep the package, you might need it to send the system to the custo-
mer service or also to store the remote control, in case you might not use the device over
a longer period.
• Please check the functional safety of your model and the remote control unit before
putting them into operation.
When doing so, make sure there is no visible damage such as defective plug connec-
tions or damaged cables. All movable parts of the model must run smoothly, but
should not have any play in their bearings.
• If questions arise which are not clarified within the course of these operating instruc-
tions, please contact us (check for contact information under chapter „introduction")
or another specialist.
The operation and control of the remote control models must be learned!
If you have never controlled a model by remote, begin carefully and first get
acquainted with the reactions of the model to the commands of the remote
control. Be patient!

b) Operation

• If you are not yet familiar with the handling of remote-controlled models, please
contact an experienced model sportsperson or a model construction club.
• Before putting your device into operation, make sure that inside the range of the
remote control there are no other models being operated on the same frequency
resp. channel. You will loose control of the remote-controlled models!
Always use different frequencies/channels.
• Always swith on the receiver first before commissioning. Only then the receiver may
be switched on in the model. Otherwise unpredicted reaction may occur with the
model! Extend the telescope antenna of the receiver to its maximum length.
• Before operation, check if the standing model reacts as expected to commands of the
remote control.
• Always make sure that when operating the model there are no body parts or objects
in the danger zone of engines or other winding operation parts (e.g. propeller, rotors).
• The incorrect handling of the device can cause heavy damage and injuries to persons
or objects! Always keep direct eye contact to the model and therefore do not use it at
nights.
• Control your model only when your reaction is unrestricted. Tiredness, influence of alco-
hol and tablets can cause failing reactions.
• Operate your model in an area where you do not endanger other persons, animals or
property. Only use it on private or specially marked areas.
112