Using The Cooking Hob; Switching On The Burners - NEFF F 3430 Serie Gebrauchsanleitung

Using the cooking hob

Switching on
the burners
One-hand ignition
74
Make sure that the flame caps, the burner caps
and the pan supports are fitted correctly.
During normal operations, the appliance heats up
considerably. Caution should therefore be used.
Do not allow children to approach the appli-
ance. Do not leave the cooking hob unattended
while it is on.
All the hob burner knobs have the following sym-
bols:
tap closed
high flame
low flame
The low flame setting is found by turning the knob
anticlockwise all the way. All intermediate settings
must be selected between the high flame and low
flame, never between high flame and closed.
The hob burners are equipped with an one-hand
ignition system. To switch on one of the burners,
press the knob corresponding to the required
burner and turn it anticlockwise to the high setting
. Hold down the knob to activate the automatic
one-hand ignition system. When the burner is on,
hold down the knob for approximately 10 sec-
onds, to allow the safety valve to open. In the
event of a power cut, the burner can also be lit
with a match (see section "Manual lighting").
Should the burner switch off accidentally, the safe-
ty thermocouple blocks the gas flow, even when
the tap is open.
The device should not been activated for longer
than 15 seconds. If after that time it fails to oper-
ate stop pressing the knob, open the window and
wait 1 minute before trying again. In case the
flame goes out accidentally turn off the knob and
do not try to switch on the burner for at least
1 minute.