VOLTCRAFT V-CHARGE 100 DUO Bedienungsanleitung Seite 95

• Briefly push the button "START/ENTER"; the number of cycles flashes (how often the cur-
rently set sequence of charging/discharging or discharging/charging is performed).
• Set the cycle number with the buttons "INC" and "DEC" (1 - 5 cycles are possible).
• Briefly push the "START/ENTER" button to confirm the setting. The display stops flashing.
• To start cycle operation, keep the "START/ENTER" button pressed for longer (approx. 3 sec-
onds).
If the settings are wrong, or if the charger detects a problem, an audio signal is emit-
ted and the appropriate information is shown in the display. You can stop the warning
signal by pressing the "BATT. TYPE/STOP" button. The charger then returns to the
previous configuration menu.
The display shows, e.g., the following data while charging or discharging:
The rechargeable battery type is shown in the upper left
("NiMH" = NiMH rechargeable battery), the upper mid-
dle shows the charging or discharging current and the
upper right the current rechargeable battery voltage.
The lower left shows the selected cycle operation ("C>D" = Charge/discharge, "D>C" = Dis-
charge/charge), the middle shows the elapsed charging or discharging duration and the right
next to it the charged or discharged capacity in mAh.
• Once cycle operation has been completed, an audio signal is emitted (if it has not been turned
off).
To interrupt cycle operation, push the button "BATT. TYPE/STOP".
NiMH 2.0A
C>D 022:45 00890
7.42V
95