Settings - Topcom Butler 200 Bedienungsanleitung

correct openings on the backside of the base station.
• Check the power supply of the adaptor.
• Check if the delivered adaptor has been used.
OUTGOING CALLS ARE NOT POSSIBLE / WRONG DIALLING MODE
• Change the dialling mode (pulse dialling/tone dialling).
BAD CONNECTION
• The handset is too far away from the base station, move closer.
YOU HEAR AN INTERMITTENT BEEP DURING THE CONVERSATION
• You are too far away from the base station, if you do not move closer to the
base station within 10 seconds, the conversation will be broken.
• Possibly the 15 minutes conversation timer is activated. Press a numerical
button (0-9) to continue the conversation.
• When the battery symbol appears on the display of the handset, the battery
needs to be charged.
DEFAULT SETTING
• To reset the telephone into factory settings, enter the following code:
7 ---- 49
20

10. SETTINGS

Dialling mode 2 xxxx 10
2 xxxx 11
Pause time 2 xxxx 31
2 xxxx 32
2 xxxx 33
2 xxxx 34
Electronic lock 1 xxxx 11
1 xxxx 10
R-button
Change PIN code
1 xxxx * # - - - -
15 min conversation timer
1 xxxx 31
1 xxxx 30
Babycall (help call)
1 xxxx 42 (tel. nr.)
1 xxxx 41
1 xxxx 40
Key tone
1 xxxx 51
1 xxxx 50
Paging (from handset to base station)
5
Temporary tone dialling (during pulse dialling)
*
21
Tone dialling
Pulse dialling
1s pause time
2s pause time
3s pause time
4s pause time
activate automatically
deactivate automatically
activate
- - - - (- - - -=new PIN code)
activate
deactivate
enter telephone number
activate babycall
deactivate babycall
activate
deactivate