Hirschmann PowerMICE Handbuch Seite 270

EtherNet/IP
Der Switch unterstützt zusätzliche herstellerspezifische Attribute.
Id Attribute
100 Ethernet Inter-
(64 face Index
H)
101 Port Control
(65
H)
102 Interface
(66 Utilization
H)
103 Interface
(67 Utilization
H) Alarm Upper
Threshold
104 Interface
(68 Utilization
H) Alarm Lower
Threshold
105 Broadcast Limit Get/Set
(69
H)
106 Ethernet
(6A Interface
H) Description
Tab. 35: Hirschmann-Erweiterungen des Ethernet Link-Objekts
a. Einheit: 1 Hundertstel von 1%, d.h., 100 entspricht 1%
270
Access Data type
rule
Get UDINT
Get/Set DWORD
Get UDINT
Get/Set UDINT
Get/Set UDINT
UDINT
Get STRING
[max. 64 Bytes]
even number of
Bytes
10.2 EtherNet/IP-Parameter
Description
Interface/Port Index (ifIndex from MIB II)
Bit 0 (RO): Link state (0: link down, 1: link up)
Bit 1 (R/W): Link admin state (0: disabled,
1: enabled)
Bit 8 (RO:) Access violation alarm
Bit 9 (RO): Utilization alarm
The existing Counter from the private MIB
hmIfaceUtilization is used. Utilization in
a
percentage . RX Interface Utilization.
Within this parameter the variable hmIface-
UtilizationAlarmUpperThreshold can be
accessed.
Utilization in percentage
zation Upper Limit.
Within this parameter the variable
hmIfaceUtilizationAlarmLowerThreshold can
be accessed.
Utilization in percentage
zation Lower Limit.
Broadcast limiter Service (Egress BC-Frames
limitation, 0: disabled), Frames/second
Interface/Port Description
(from MIB II ifDescr), e.g. "Unit: 1 Slot: 2 Port:
1 - 10/100 Mbit TX", or "unavailable",
max. 64 Bytes.
UM Grundkonfiguration L3P
a
. RX Interface Utili-
a
. RX Interface Utili-
Release 7.1 12/2011