Usb Playback; Using The Usb Interface - Pioneer DV-600AV-S Bedienungsanleitung

USB playback

Chapter 6
USB playback

Using the USB interface

It is possible to listen to two-channel audio and
watch JPEG files using the USB interface on
the front of this unit. Connect a USB mass
storage device as shown below.
Note
• This includes playback of MP3/WMA/
MPEG-4 AAC/JPEG files (except files with
copy-protection or restricted playback).
• Compatible USB devices include portable
flash memory (particularly keydrives) and
digital audio players (MP3 players) of
format FAT16/32. It is not possible to
connect this unit to a personal computer
for USB playback.
• Pioneer cannot guarantee compatibility
(operation and/or bus power) with all USB
mass storage devices and assumes no
responsibility for any loss of data that may
occur when connected to this unit.
• With large amounts of data, it may take
longer for the system to read the contents
of a USB device.
• The Home Menu cannot be displayed
while using the USB mode.
1 With the player switched on, press
DVD/USB.
Make sure your TV is on and set to the correct
video input, and that USB MODE is showing
on the front panel display.
2 Connect your USB device.
The USB terminal is located on the front panel.
USB
STANDBY/ON
DV-600AV
• Disc Navigator is automatically displayed.
DVD/USB HDMI
USB
(Type A)
USB mass
storage device
3 Press ENTER to start playback.
• The method of playback for files saved on a
USB device is the same as for other discs.
For more information, see Basic playback
controls on page 22 and Playing discs on
page 26.
4 Turn off this player and remove the
USB device.
• The next time you turn this player on it will
start up in USB mode. To return to DVD
mode, either press DVD/USB or press
OPEN/CLOSE to open the disc tray.
Important
If a USB ERR message lights in the display, it
may mean that the power requirements of the
USB device are too high for this player, or that
the device is incompatible. Try the following:
• Switch the player off, then on again.
• Reconnecting the USB device with the
player switched off.
• Change the player back to DVD mode
(LOADING will appear in the front panel
display whether a disc is inserted or not) by
pressing DVD/USB, then once again
select USB mode (USB MODE will appear
in the front panel display).
• Using a dedicated AC adapter (supplied
with the device) for USB power.
If this doesn't remedy the problem, it is likely
your USB device is incompatible.
06
35
En