Setting The Damping - WIKA UPT-20 Betriebsanleitung

8. Configuration via display and operating unit
4. Select "Mounting corr." and confirm with [↵].
5. Select "change" and confirm with [↵].
6. Change digit using [▲] [▼] and confirm with [↵]. The cursor
moves to the next digit. Repeat for each digit.
» Entered value will be used as the new zero point.

8.6 Setting the damping

The damping prevents the fluctuation of the output signal when there are short-term
fluctuations in the measured value. Safety shut-downs due to turbulent processes are
thus prevented.
Pressure spikes will still be registered, e.g. as P
"Diagnostic".
Setting range 0 ... 99.9 s
1. Open the operating menu with [↵].
Select "Basic setting" and confirm with [↵].
2. Select "Damping value" and confirm with [↵].
3. Change digit using [▲] [▼] and confirm with [↵]. The cursor
moves to the next digit. Repeat for each digit.
» Damping is set.
WIKA operating instructions process transmitter, model UPT-2x
in the menu point
max
EN
41