Recording All Markers In The Ltc User Bits; Recording Shot Data In The Vitc User Bits; Disabling The Ntsc/Pal Switch To Operate In Ntsc Mode - Sony DNV-5 Bedienungsanleitung

5-5 VTR Menu Display in the Display Panel
Sounding a tone on starting and stopping
recording
1
Hold down the ADVANCE button and press the
SHIFT button for at least one second.
This displays the VTR menu.
2
Press the ADVANCE button twice.
3
Press the SHIFT button.
The current setting of REC START/STOP TONE
flashes.
4
Press the ADVANCE button until the displayed
setting value is 1.
5
Press the SHIFT button three times.
This saves the new setting value.
6
Hold down the ADVANCE button and press the
SHIFT button to exit the VTR menu.
If the new setting is not saved correctly
When you press the SHIFT button in step 5, an
indication "3:Ex xx" appears. Make the setting once
more.

Recording all markers in the LTC user bits

1
Hold down the ADVANCE button and press the
SHIFT button for at least one second.
This displays the VTR menu.
2
Press the ADVANCE button three times.
3
Press the SHIFT button twice.
The current setting of LTC UBIT MARKER
flashes.
4
Press the ADVANCE button until the displayed
setting value is 1.
5
Press the SHIFT button three times.
This saves the new setting value.
6
Hold down the ADVANCE button and press the
SHIFT button to exit the VTR menu.
5-16(E)
Chapter 5 Adjustments and Settings for Recording
If the new setting is not saved correctly
When you press the SHIFT button in step 5, an
indication "4:Ex xx x" appears. Make the setting once
more.

Recording shot data in the VITC user bits

1
Hold down the ADVANCE button and press the
SHIFT button for at least one second.
This displays the VTR menu.
2
Press the ADVANCE button four times.
3
Press the SHIFT button.
The current setting of VITC UBIT flashes.
4
Press the ADVANCE button until the displayed
setting value is 2.
5
Press the SHIFT button twice.
This saves the new setting value.
6
Hold down the ADVANCE button and press the
SHIFT button to exit the VTR menu.
If the new setting is not saved correctly
When you press the SHIFT button in step 5, an
indication "5:Exx" appears. Make the setting once
more.
Disabling the NTSC/PAL switch to operate
in NTSC mode
1
Hold down the ADVANCE button and press the
SHIFT button for at least one second.
This displays the VTR menu.
2
Press the ADVANCE button five times.
3
Press the SHIFT button.
The current setting of NTSC/PAL SW flashes.
4
Press the ADVANCE button until the displayed
setting value is 1.
5
Press the SHIFT button five times.
This saves the new setting value.
6
Hold down the ADVANCE button and press the
SHIFT button to exit the VTR menu.