Shooting And Recording/Playback Functions - Sony DNV-5 Bedienungsanleitung

2-4 Shooting and Recording/Playback Functions

1 VIDEO OUT (video output) connector (BNC
type)
This connector outputs a composite signal (standard
level, 75-ohm terminated) to the video monitor. If the
video monitor is connected here, you can monitor the
picture being shot by the video camera as well as the
picture recorded by the DNV-5. When synchronizing
the time code of an external VTR with that of the
DNV-5, connect this connector to the video input
connector of the external VTR.
2 VTR REMOTE (remote control) connector
(6-pin)
Connect the VA-DN1 Camcorder Interface Adaptor
(not supplied) to this connector.
By connecting a VA-DN1 Camcorder Interface
Adaptor (not supplied) to this connector, it is possible
to control the VTR from a 9-pin remote control device.
2-6(E)
Chapter 2 Locations and Functions of Parts and Controls
EJECT REW
0
6
STOP
p
1 VIDEO OUT connector
2 VTR REMOTE connector
3 TEST OUT connector
Shooting and recording/playback functions
4 EJECT button
5 REW button and indicator
F FWD
6 F FWD button and indicator
)
PLAY
7 PLAY button and indicator
8 STOP button
Note
If the VTR REMOTE and TEST OUT connectors are
used at the same time, it may not be possible to
generate video signals at standard levels.
3 TEST OUT (test output) connector (BNC type)
This connector outputs the video signal (standard
level, 75-ohm terminated) for the video monitor.
Depending on the settings of the MENU CANCEL/
ITEM switch and the SUPERIMPOSE ON/OFF
switch, the setup menu, the time code or the shot data
can be displayed over the image on the monitor. As for
the VIDEO OUT connector, you can use this
connector for synchronizing the time code of an
external VTR to the time code of the DNV-5.
4 EJECT (cassette eject) button
Press this button to eject or load a cassette.