Operating The On-Screen Display At The Console; Showing The On-Screen Display At The Console; Layout Of The On-Screen Display - G&D DP1.2-Vision-CAT Bedienungsanleitung

Configuration
Function
Changing the colour of the information display
Information display
Adjusting the transparency of the on-screen display
Changing the position of the information dispaly
Changing the position of the on-screen display
The basic operation of the on-screen display (see page 20) and the web application
Config Panel (see page 22) is described on the following pages.

Operating the on-screen display at the console

The on-screen display (OSD) – just like the web application
described on the following – can be used to change the configuration of the KVM
extender.
The on-screen display can be opened by pressing a configured hotkey at the user
module. You can view and edit the settings of the KVM extender only in the remote
OSD of the computer module.
NOTE:
Use the remote hotkey
ure the remote OSD of the computer module and the
to open and configure the local OSD of the user module.
During the starting process of the user module, the settings of both hotkeys are
shown (see Starting process on page 12).

Showing the on-screen display at the console

How to open the on-screen display:
1. Press
Ctrl+Num

Layout of the on-screen display

After pressing the hotkeys, the OSD is displayed on the console monitor:
The on-screen display consists of three parts:
20 · G&D DP1.2-Vision-CAT
(default:
(standard) to open the on-screen display.
Configuration
Console setup
Local console setup
Target setup
System setup
Network setup
Information
Target power
ESC
Default setting
light green
temporary
average transparency
left upper corner
centred
Ctrl + Num ) at the console to open and config-
local hotkey
turn off
Config Panel , which is
(default: Alt +

...
...
...

...
...
...

Page
45
46
47
48
48
Num )