Operating The On-Screen Display At The Console; Showing The On-Screen Display At The Console - G&D VisionXS-C-DP-UHR Installation Und Bedienung

Configuration
Function
Resetting the default settings
Resetting the netfilter rules
Changing the colour of the information display
Information display
Adjusting the transparency of the on-screen display
Automatic closing of the OSD after inactivity
Changing the position of the information dispaly
Changing the position of the on-screen display
The basic operation of the on-screen display (see page 21) and the web application
(see page 24) is described on the following pages.
Config Panel

Operating the on-screen display at the console

The on-screen display (OSD) – just like the web application
described on the following – can be used to change the configuration of the KVM
extender.
The on-screen display can be opened by pressing a configured hotkey at the user
module.
NOTE: Use the remote hotkey
the remote OSD of the computer module and the
open and configure the local OSD of the user module.
During the starting process of the user module, the settings of both hotkeys are
shown (see Starting process on page 15).

Showing the on-screen display at the console

How to open the on-screen display:
1. Press Ctrl+Num
NOTE: In the default settings,
display. To switch to a different language, press
guage. English is assumed to be selected in the following chapters.
21 · G&D VisionXS-C-DP-UHR
(default: Ctrl
(default) to open the on-screen display.
English
Default setting
light green
temporarily
average transparency
deactivated
left upper corner
centre
+ Num ) at the console to open and configure
local hotkey
is selected as the language for the on-screen
and select the desired lan-
F10
Page
52
53
54
55
56
57
58
59
Config Panel , which is
(default: Alt + Num ) to