Assembly; Scope Of Delivery; Workplace; Transport / Unloading The Machine - Holzmann KF 200L Originalbetriebsanleitung

These risks can be minimized if all safety rules are applied, the machine is properly maintained
and serviced the machine as intended and is serviced by a trained service professional. Despite
all the safety devices and remains her good common sense and your appropriate technical quali-
fication / training on the operation of a machine such as the sliding table saw KF 200L is the
most important safety factor!
14

ASSEMBLY

14.1

Scope of delivery

The machine is supplied pre-assembled. After receipt of the delivery, if all parts are in order. Report
any damage or missing items immediately to your dealer or the shipping company. Visible damage
must also be recorded without delay in accordance with the provisions of the warranty on the deliv-
ery note, otherwise the goods shall be accepted as properly.

14.1.1 Workplace

Choose a suitable place for the machine. Observe the safety requirements of Chapter 12 and the
dimensions of the machine from Chapter 11.
The selected location must ensure as well as the possibility for connection to an extraction system a
suitable connection to the electrical grid.
Make sure that the floor can support the weight of the machine. The machine must be leveled on all
bases simultaneously.
You must also secure around a distance of at least 0.8 m around the machine. Before and behind
the machine must be provided the necessary distance for the supply of long workpieces.

14.1.2 Transport / unloading the machine

You need a forklift with the necessary capacity.
The forks of the forklift will be led to the machine.
If a crane is in place, operate as follows:
- There are 2 ropes or belts prepared with the necessary capacity and length.
- The ropes are hung on the crane hook, the crane must possess the relevant capacity. The
ropes are lifted by crane in preparation. Now the four loops are hooked into the holes provid-
ed on the machine.
- The ropes straighten well. If necessary, the crane to move a little vertical and to secure sta-
ble lifting. The machine does not tend. Safe tether - eyelet!
- The lifting of the machine must go slowly and without bumping and rocking on.
- After the machine is lifted about 1 m, pause, and fasten the four leveling legs on the body of
the machine.
- Remove the rails and stop the machine with the crane on the chosen course.
- Bring about a stable horizontal position with the four leveling legs.
HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Kreissäge – Fräse / circular saw – spindle shaper combination
ASSEMBLY
Seite 28
KF 200L