Operation; Before Commissioning; Extraction Port Assembly (Fig. 2-3 / Pos.1); Parallel Stop Assembly (Fig. 4 / Pos.21) - Holzmann OBF 1200 Betriebsanleitung

10

OPERATION

10.1

Before commissioning

10.1.1 Extraction port assembly (Fig. 2-3 / Pos.1)

 Connect your router to the suction (1) with inner Ø 36mm at an extraction.
 Squeeze the two plastic shells (1A and 1B) as in the picture.
 Suction (1) with the two countersunk screws (f) on Routing shoe (2) with screws.

10.1.2 Parallel stop assembly (Fig. 4 / Pos.21)

 Push the guide shafts (a) of the parallel stop (21) into the holes (b) on the routing shoe
(2).
 Set the parallel stop (21) to the required dimension and secure in place with the fixing
screws (3).

10.1.3 Fitting the compass point (Fig. 5)

 With the compass point (13) -and the associated support- you can mill circular areas.
 Clamp the compass point (13) on the end of one of the guide rod (a).
 Slide the guide bar (a) in a hole (c) of routing shoe (2) a. Fasten the guide bar (a) with the
fastening screws (3) on routing shoe (2).
 Set the desired radius between circle tip (13) and cutter a.
 Place the compass point (13) in the middle of the circle to be milled. Loosen, if necessary,
the wing nut (b) the compass point (13) and extend / shorten the downward part of the
compass point (13).

10.1.4 Guide sleeve assembly (Fig. 6-7 / Pos.20)

 Fasten the guide sleeve (20) with the two countersunk screws (f) on routing shoe (2).
 The guide sleeve (20) with the thrust ring (b) on the template (c) guided along.
 The workpiece (d) must make up the difference "outer edge ring fence" and "outer edge
router" (e) must be greater in order to obtain an exact copy.

10.1.5 Fitting / Removing the cutting tool (Fig. 8-11)

In this router cutters can be used with a shank diameter of 6mm and 8mm.
You can among other things Cutters made of the materials used:
HSS - geeignet zur Bearbeitung von Weichhölzern
TCT - suitable for machining
Clean nut, collet and shaft of the mill prior to
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Perform all refitting only separation from the mains by!
Cutters are very sharp. When handling with milling cutters Always wear protective
gloves.
hardwoods,
ATTENTION
particle board, plastics and
insertion.
OPERATION
aluminum.
22
OBF 1200