Network Settings; Configuring The Network Interfaces - G&D DP1.2-MUX3-ATC Installation Und Bedienung

Network settings

The device provides two network interfaces (Network A and Network B). The network
interfaces allow you to integrate a device into up to two separate networks.

Configuring the network interfaces

To connect the device to a local network, you need to configure the network set-
tings.
NOTE: By default, the following settings are preselected:
 IP address of Network interface A:
192.168.0.1
 IP address of Network interface B:
Obtain settings via
 Global network settings
Obtain settings via
How to configure the settings of a network interface:
IMPORTANT:
The operation of both network interfaces within one subnet is not
permitted.
NOTE: The Link Local address space 169.254.0.0/16 iis reserved for internal com-
munication between devices according to RFC 3330. It is not possible to assign an
IP address of this address space!
1. Press Ctrl+Num (default) to open the on-screen display.
2. Press to open the configuration settings.
F11
3. Use the
arrow keys
4. Use the arrow keys
5. Enter the following values under
Operational
mode:
IP address:
Netmask:
6. Press F2 to save your settings.
DHCP
DHCP
to select and press
Network
to select Interfaces and press
Interface A
Select the operational mode of
 Off: Switch off network interface.
 Static: A static IP address is assigned.
Obtain IP address from a DHCP server.
 DHCP:
Enter the IP address of the interface - only if the operating
mode Static is selected.
Enter the network netmask - only if the operating mode Static
is selected.
Configuration settings in the OSD
.
Enter
Enter .
or Interface B :
Interface A or Interface B
G&D DP1.2-MUX3-ATC · 23
: