Aim-TTI PL-P SERIES Bedienungsanleitung Seite 4

Output Terminals:
Over-Voltage Protection:
Output Protection:
Load & Line Regulation:
Ripple and Noise:
Transient Response:
Temperature Coefficient:
Meter Type:
Meter Resolution:
Meter Accuracy:
LOGIC OUTPUT - REMOTE OPERATION
All specifications identical to LOCAL operation, with the following additions/exceptions:
Output Voltage Range:
Output Current:
Voltage Setting Accuracy:
Output Switch:
Current Readback Resolution:
Current Readback Accuracy:
REMOTE CONTROL INTERFACES
Both interfaces feature full control, readback and status reporting.
RS232:
GPIB:
Address Selection:
Remote/Local Operation:
Remote Command
Response Times:
Interface:
Output Voltage - Up:
Output Voltage - Down
Output Current:
Remote via 4mm terminals or direct via shorting links (provided).
Above 7 Volts.
Clamped by the over-voltage protection circuit for forward voltages over
7 Volts and up to 1 Amp forward current. Diode clamped for reverse
voltages and up to 3 Amps reverse current.
< 0·01% of maximum output for 90% load change, or 10% line change.
Typically <1 mV rms.
< 20 µsec to within 50mV of setting for 90% load change.
Typically < 100ppm/°C.
3·75 digit (4095 count) with 12·5mm (0·5") LEDs. Reading rate 4 Hz.
10mV and 10mA
0·5% of reading + 1 digit.
4 to 6 Volts in 10mV steps.
1 to 7 Amps in approximately 1 A steps.
0·2% ± 10mV
Electronic by interface command (front panel switch must be ON).
10mA
0·5% of reading + 1 digit.
Variable Baud rate (9600 maximum), 9 pin D-connector (female).
Fully compatible with ARC (Addressable RS232 Chain) system.
Conforming with IEEE-488.1 and IEEE-488.2.
By rear panel DIP switch.
Selected by front panel switch.
<15ms (single command, input buffer empty).
Time constant typically 2ms, e.g. 10ms to settle within 1% of a step
change, 15ms to settle within 0·1%.
Time constant determined by the discharge of the power supply output
capacitor (47µF). Typically <10ms to settle within 1% for a 10V step
change at 50mA load current; typically <200ms to settle within 1% at
zero load.
Typically 50ms to settle within 10mA for a 1A change.
3