Cleaning And Maintenance; Cleaning The Filter-Bag; Cleaning And Storage - Zodiac Pool First O'Clair Montage- Und Gebrauchsanleitung

2-Notice Poolfirst ANG_Mise en page 1 05/01/11 11:06 Page17

CLEANING THE FILTER-BAG

We recommend cleaning the filter-bag after each cycle. Do not let debris or dirt dry up in
the filter-bag. This would make it very difficult to clean and could make it unusable.
Ensure that the power cable is unplugged from the power mains or that the floating cable is
disconnected from the power supply unit.
> Lift the robot out of the water and place it upside down on the deck, so as to enable access
to the filter-support plate fitted on the underside.
> Pull back the 4 clips that hold the plate in place. Remove the plate, keeping it upside down
so that the contents remain in the bag.
> Undo the 2 plastic clips to extract the bag.
> Gently pull back the elastic band at the base of the filter and remove the latter from its support
plate.
> Empty the bag and clean it using tap water or if necessary using slightly soapy water. In this
case, rinse thoroughly, taking care to turn it over. It can be washed in a washing machine
following the instructions mentioned on the label fitted on the inside of the bag.
> Also rinse the filter support plate and remove any impurities that might be stuck under the clips.
> Replace the filter-bag by placing the knot in the elastic band at the middle of the length
of the filter-support, and the corners of the bag on the angles of the metal rods. The
Zodiac label is fitted to one of the metal rods.
> Place the plastic locking clips on the rods.
> Replace the filter-support and clip it into place.
Figure 7

CLEANING AND STORAGE

The robot must be cleaned regularly using plain tap water or slightly soapy water, excluding any
detergent such as trichloroethylene or equivalent products.
Rinse the robot thoroughly using tap water.
None of the external mechanical parts accessible to the user require greasing.
The robot must be stored on its carry cart, which has been specially designed to avoid squashing
the brushes and to ensure that it can dry safely and quickly.
IMPORTANT :
Do not leave the robot to dry in the sun by the pool side.
Do not leave the control unit in the sun or under the rain.

3 / CLEANING AND MAINTENANCE

Figure 10.
Figure 8
Figure 7.
Figure 8.
Figure 9.
Figure 9
17
Figure 10