Changing The Brushes - Zodiac Pool First O'Clair Montage- Und Gebrauchsanleitung

2-Notice Poolfirst ANG_Mise en page 1 05/01/11 11:06 Page18
THE ROBOT IS FITTED WITH SEBS RUBBER PADS (STANDARD)
The rubber pads include wear indicators. To ensure that your swimming pool cleaner remains
highly efficient, you must change the brushes as soon as one of the wear indicators has
been reached (even if the strips are not evenly worn).
We recommend changing the brushes after 2 seasons of use.
To change the brushes:
> Turn the robot on its back.
> Pull the strips through the slots in the first brush.
> Remove the worn brush.
> Place the new brush by wrapping the smooth part with no strips around the brush support.
Figure
> Insert each strip in the corresponding notch and pull gently on the strips in order to pull them
through to the other side of the slot.
> Cut the strips using a pair of scissors to match their length with that of the other strips.
Figure
> Repeat the above operations on the second brush.
Figure 11
THE ROBOT IS FITTED WITH FOAM PADS
We recommend that you change the pads after a season's use. It is essential that they are
changed as soon as their surface becomes smooth or worn.
In order to do this, proceed as follows:
> Turn the robot over.
> Push the pads aside to reveal the pad clips. Slide your fingers under the pads in order to release
the clips holding them in place. Be careful not push them too far.
> Remove the used pads and replace them with new ones (with the smooth side facing inwards).
> Replace the clips.
> Retighten the pads.
Figure 15

4 / CHANGING THE BRUSHES

12.
14.
Figure 12
Figures 17 and 18.
Figure 16
Figure 11.
Figure 13.
Figure 13
Figures 15 and
Figure 17
18
Figure 14
16.
Figure 18