Intended Use; Non-Intended Use - TR-Electronic CDH 75 M Benutzerhandbuch

2.4 Intended use

The safety measuring system can be used for the detection of angular movement
and processing of measured data for a downstream safety host (Control system) in
systems in which the goal of "Protection of travel" must be safely achieved. The
complete processing chain of the safety function must then satisfy the requirements
of the applied safety standard.
The safety measuring system must only be used in safety applications in conjunction
with a control certified according to the applied safety standard.
The system manufacturer must check that the characteristics of the measuring system
satisfy his application-specific safety requirements. The responsibility or decision
regarding the use of the measuring system lies with the system manufacturer.
Intended use also includes:
●
observing all instructions in this User Manual,
●
observing the nameplate and any prohibition or instruction symbols on the
measuring system,
●
observing the enclosed documentation, e.g. product insert, connector
configuration etc.
●
observing the operating instructions from the machine/system manufacturer,
●
operating the measuring system within the limit values specified in the technical
data,
●
ensuring that the fail-safe processing unit (Control system) fulfils all required
safety functions,
●
observing and using the checklist in the Appendix,
●
safe mounting of the measuring system to the driving axis

2.5 Non-intended use

Danger of death, physical injury and damage to property in case of non-
intended use of the measuring system!
Printed in the Federal Republic of Germany
10/11/2017
 The following areas of use are especially forbidden:
in environments where there is an explosive atmosphere
-
for medical purposes
-
TR - ECE - BA - DGB - 0070 - 16
 TR-Electronic GmbH 2009, All Rights Reserved
Page 69 of 108