Start Up; Attaching The Accessories; Power Supply; Water Connection - Kärcher HD 10/16-4 Cage Bedienungsanleitung

DANGER
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. If they are not in a perfect state
then the appliance must not be used.
 Lock parking brake.
Check oil level
 Cut off tip of oil filling nozzle.
 Check oil level of the high pressure
pump.
The oil level must be between the "MIN"
and "MAX" markings on the oil container.
 Add oil if required (see technical speci-
fications).
ATTENTION
Risk of damage! In case of lacteous oil inform
Kärcher customer service immediately.
Installing the pushing handle
 Install the pushing handle on the pipe
frame.

Attaching the Accessories

Note: The EASY!Lock system joins com-
ponents with a quick-fasten thread solidly
and securely with just one turn.
1.
 Insert the high pressure nozzle onto the
spray lance.
 Install union nut and hand-tighten it
(EASY!Lock).
 Join the spray lance with the trigger gun
and tighten until hand-tight
(EASY!Lock).
 Connect high pressure hose and spray
pipe to the hand spray gun.
18

Start up

2.
– For connection values refer to technical
specifications.
– The electrical connections must be
done by an electrician according to IEC
60364-1.
– The machine is equipped as standard
with an Ex plug. If the existing socket
does not match this plug, it must be ad-
justed accordingly by a technician.
WARNING
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded.
In case of any uncertainty regarding the
present net impedance at your connection
point, please contact your local power sup-
ply company.
DANGER
– Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the socket.
– Unsuitable electrical extension cables
can be hazardous. Only use electrical
extension cables outdoors which have
been approved and labelled for this pur-
pose and have an adequate cable
cross-section.
1 - 10 m: 2.5 mm
10 - 30 m: 4 mm

Water connection

WARNING
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a conductive (electrostatically)
hose (resistance R < 10
cluded). Minimum diameter, 3/4 inch.
 Connect the hose to the water connec-
tion of the appliance.
 Connect the hose to the water tap.
ATTENTION
Never operate the high pressure cleaner
when the tap is closed because dry running
can damage the high pressure pump.
– 4
EN

Power supply

2
2
Ohm, not in-
6