Generic Functions; A) Analogue Bar Graph; B) Range - Manually Selecting The Measuring Range - VOLTCRAFT VC-750E Bedienungsanleitung

13. Generic functions

Some measuring modes support additional functions that are summarized in this chapter.
• Enabling and disabling of generic functions (that can be turned on and off) are confirmed by a beep.

a) Analogue bar graph

The bar graph is an approximate and analogue reflection of the values the main display shows.
Depending on the selected range, the graph's accuracy differs. Study below example diagram on 60/600 A:
b) RANGE – Manually selecting the measuring range
When there is interference, the multimeter may select the incorrect measuring range or alternate between two ranges.
Depending on the selected measuring mode, you can set the measuring range manually.
For a complete collection and breakdown of ranges for each function, consult the technical data section.
Manually control the range as follows:
1. Press the RANGE button. The [ AUTO ] symbol will disappear from the display.
2. Press the RANGE button again to select the next measuring range (if the highest measuring range is selected,
the multimeter will go back to the lowest range). The measuring range is indicated by the position of the decimal
point.
3. To disable manual range selection, press and hold the RANGE button for 2 seconds. The [ AUTO ] symbol will
be displayed to indicate that the multimeter will select the measuring range automatically.
- You can also disable manual range selection by switching to another measuring mode.
52