Shooting; Basic Recording Operation - JVC GY-DV300 Bedienungsanleitung

SHOOTING

4.
ZOOM lever
5.
REC START /STOP button
1.
POWER
switch
2.
MODE
switch
MODE
CAM-B
CAM-A
GAIN
● Setting the recording mode
(AUTO/MANUAL)
The recording mode is set by
means of the MODE item on the
TOP MENU screen. (
page 47, 48.)
LCD screen
VTR mode indication

Basic Recording Operation

POWER
OFF
ON
VTR
SHUTTER
This section explains the basic recording procedures when the AUTO
mode is selected as the shooting mode.
1.
Set the POWER switch to "ON".
Power is supplied to the unit.
See
2.
Set the MODE switch to "CAM-A" or "CAM-B".
The GY-DV300 enters the shooting mode.
● The set values indicated on the menu screen will be either
those of "CAM-A" or "CAM-B" in accordance with the setting
of the MODE switch.
3.
Slide the EJECT switch to open the cassette cover.
Ensure that the erasure-prevention switch on the back of the
cassette is set to REC and insert a videocassette properly.
Slowly push the "PUSH HERE" section on the cassette holder
with a finger until a click is heard. Confirm that the cassette
holder does not come up when you remove your finger.
The tape is loaded and the unit enters the recording-standby
mode when the cassette cover is closed.
● When the recording-standby mode is engaged, STBY is
indicated as the VTR mode on the LCD screen and the
viewfinder screen.
Memo:
A
After the cassette cover is closed, it takes about 11 seconds
before the unit is ready for recording.
Handle
5.
REC START/STOP
button
3.
EJECT switch
4.
ZOOM lever
Cassette cover
E-57