Disposal - Hilti PR 30-HVS Bedienungsanleitung

Fault
The display shows this symbol
en
The display shows this symbol
The display shows this symbol
The display shows this symbol

10 Disposal

WARNING
Improper disposal of the equipment may have serious consequences:
The burning of plastic components generates toxic fumes which may present a health hazard.
Batteries may explode if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution.
Careless disposal may permit unauthorized and improper use of the equipment. This may result in serious personal
injury, injury to third parties and pollution of the environment.
Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative for further
information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
40
Possible cause
The command is valid but the tool
doesn't react.
The tool is in surveillance mode. Re-
alignment was not possible.
The tool is in sleep mode (the tool
will remain in sleep mode for max.
4 hours).
The state of charge of the PR 30-HVS
battery is low.
Remedy
Switch on all tools and make sure
they are within wireless communic-
ation range.
Check to ensure there are no obstruc-
tions between the tools. Do not ex-
ceed the maximum wireless com-
munication range. For good wireless
communication, the PR 30-HVS and
PRA 30 should be positioned ≧ 10 cm
(4 in) above floor level.
Check the positions of the PR 30-
HVS and PRA 30 and make sure that
the line of sight between the PR 30-
HVS and PRA 30 is unobstructed. Re-
start automatic alignment (see section
on automatic alignment and surveil-
lance mode).
Activate the tool (see section "Deac-
tivating sleep mode")
Charge the battery, use a different
battery or use the PR 30-HVS in
"charging during operation" mode
(not suitable outdooors or in damp
conditions).