Troubleshooting - Megasat HD 570 CI Benutzerhandbuch

Troubleshooting

You might meet abnormal working of this STB with various reasons. Check the following which may help you.
Problem Possible causes
LED on the front panel fail to Main supply cable is not con-
light up/is not lit. nected.
No picture or sound. Satellite dish is not aiming to
satellite accurately. No signal or
weak signal. The LNB is faulty.
The cable is faulty.
Bad picture/blocking error Satellite dish is not aiming to the
satellite accurately. Signal too
strong. Satellite dish is too small.
LNB noise factor too high. The
LNB is faulty.
No startup menu on screen after The system is connected by
turning on STB for the first time. SCART cable and the TV is not in
AV/ EXT mode.
The remote control is not wor- Battery exhausted. Remote con-
king. trol is not aimed correctly STB is
in standby mode.
You have forgotten your pass-
word.
Poor picture quality or Less Low LNB power or signal loss in
channels in scanning. cable.
ENGLISH
16
What to do
Check if the main supply cable is
plugged into the power socket.
Adjust the dish. Check the sig-
nal strength indicator in one of
the channels search submenus.
Check the cable connections,
LNB and other equipment con-
nected to LNB & receiver, or
adjust dish. Replace the LNB.
Replace the cable.
Adjust the dish. Connect an at-
tenuator to LNB input. Change
to a larger dish. Change LNB
with lower noise factor. Replace
the LNB.
Switch the TV to the appropriate
AV input.
Change the batteries (both).
Aim the remote control at the
STB. Check that nothing blocks
the front panel. Check if LED
indicator on the front panel is
showing the time, press the po-
wer button to switch off standby
mode.
Contact the dealer or Service
Provider. They will help you set
it up again.
Change the LNB power to
14V/19V in Antenna setup
menu.
Notes
ENGLISH
17