Display And Device Status Indicator/Led - Endress+Hauser RMA42 Handbuch

RMA42
3. Start the macro "Service (CDI) FXA291" by double-clicking it and confirm the subsequent
query with "Yes".
 A connected device is searched and the suitable DTM is automatically opened. The
configuration starts.
To then configure the device itself, follow these Operating Instructions for the device. The
entire Setup menu, i.e. all the parameters listed in these Operating Instructions, can also be
found in the FieldCare Device Setup.
In general, it is possible to overwrite parameters with the FieldCare PC software and the
appropriate device DTM even if access protection is active.
If access protection by means of a code should be extended to the software, this function
should be activated in the extended device setup.
For this purpose, select: Menu → Setup / Expert → System → Overfill protect → German
WHG and confirm.
6.2

Display and device status indicator/LED

The device provides an illuminated LC display which is split into two sections. The segment
section displays the value of the channel and additional information and alarms.
In the dot matrix section, additional channel information, such as the TAG, unit or bar graph,
is displayed in the display mode. Operating text in English is displayed here during operation.
The parameters for configuring the display are explained in detail in Section "Configuring the
device" in the Operating Instructions.
Endress+Hauser
Operation
41