Product Safety; Identification; Device Designation; Nameplate - Endress+Hauser RMA42 Handbuch

Identification

Environmental requirements
If a plastic transmitter housing is permanently exposed to certain steam and air mixtures, this
can damage the housing.
‣
If you are unsure, please contact your Endress+Hauser Sales Center for clarification.
‣
If used in an approval-related area, observe the information on the nameplate.
2.5

Product safety

This measuring device is designed in accordance with good engineering practice to meet state-
of-the-art safety requirements, has been tested, and left the factory in a condition in which it
is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EU/EEU
directives listed in the device-specific Declaration of Conformity. Endress+Hauser confirms
this by affixing the CE/EAC mark to the device.
3 Identification
3.1

Device designation

3.1.1

Nameplate

Compare the nameplate on the device with the following diagram:
 1 Nameplate of the process transmitter (example)
1 Device order code, serial number and ID number
2 Power supply
3 Power consumption
4 Approvals (if applicable)
5 Temperature range
6 Firmware version
30
1
2
3
4
RMA42
6
5
A0011757
Endress+Hauser