Optimising Cutting Results - struers Axitom Gebrauchsanweisung

Optimising Cutting Results

Axitom
Instruction Manual
The following table shows possible answers to a number of common
questions:
Optimising the Cutting Results
Question
How can I avoid discoloration
or burning of the sample?
How can I avoid burrs?
How can I avoid the cut-off
wheels wearing too quickly?
How can I achieve faster
cutting?
Answer
Use a lower Feed Speed.
Change the cut-off wheel as the
hardness of the present cut-off wheel
may be inappropriate for the hardness of
the sample. *)
Use a softer cut-off wheel. *)
Clamp the workpiece securely at the
right hand clamping device.
Tighten the left hand clamping device
just enough to prevent the workpiece
from moving when being cut.
Use a lower Feed Speed, a different
cutting mode or a harder cut-off wheel. *)
Position the workpiece so as to cut the
smallest possible cross-section. Use a
high Feed Speed.
If workpiece shape and properties
permit, change to ExciCut or
AxioCut/Step (optional) Cutting Modes
47