BURG WÄCHTER SET 5021 Montage- Und Bedienungsanleitung Seite 32

E-KEY battery replacement
1 Open the housing cover by carefully forcing open the detent lugs.
2 Lift the silicon pad and replace the battery.
3 Clap the silicon pad back and close the cover.
1
Keypad installation
The keypad is only included in TSE Prime PINCODE and TSE Prime
FINGERSCAN sets.
Attention! Please remember that the keypad should not be attached
to the door itself, otherwise it would transmit shocks when the
door is being shut. The membrane affixed to the keypad rear side
should not be sealed with glue and/or any other substance under
any circumstances! Exchange of air must also be possible after the
installation!
– Determine the installation place for the keypad. For that purpose, enter
the opening code (e. g. PIN code, fingerprint,...) at the desired mounting
place and check whether the lock opens.
– Place the keypad correspondingly.
You can then decide whether you want to glue the wall holder directly on
the wall or whether you prefer having it screwed on. The slotted holes in the
wall holder provide for an exact alignment.
If you decide for gluing the wall holder, please be sure to provide for clean
surfaces free from fat, oil and silicon films and any other impurities. Remove
completely the protective film from the included adhesive pads, attach all
the pads on the wall holder and then press the whole firmly to the required
position. When mounting in colder temperatures, please remember that
the full adhesive force cannot be achieved before 72 hours in 20 °C, with
warmth accelerating the process (e. g. in 65°C, the full adhesive force will be
achieved in one hour).
34 | English
2 3
TSE PRIME
W
de
ad
To
ple
– P
g
s
– A
s
a
– T
c
At
– S
l
i
k
– P
d
a
fi
B
– R
l