Samsung SCC-C9302FP Bedienungsanleitung Seite 21

CAMERA MENU Organization
BW
This is the IR Filter OFF mode, black-and-white
(with the same sensitivity as a black-and-white camera). Select BW... and press
[Enter] and the BW submenu will appear. You may determine to sent out BURST signals
by ON or OFF setting in this submenu.
E
WHITE BAL will be marked --- so that setup is unavailable.
In AUTO mode, AGC menu will be displayed as "---" and you cannot change
it manually,
CAMERA ID ON...
IRIS ALC...
SHUTTER OFF
AGC LOW
WHITE BAL ---
FOCUS MODE ONEAF
ALARM SET ...
COLOR/BW BW...
PRIVACY ON...
SPECIAL ...
PRESET ...
EXIT QUIT
40
(BW)
PRESS THE
ENTER
BURST ON
BUTTON.
RET
AUTO
Depending on illumination, it is automatically switched to the COLOR or BW mode.
In the poor illumination environment, turns IR Filter off to convert to the Black-and-
White mode for better sensitivity and in the good illumination environment, turns it on
to convert to the COLOR mode for worse sensitivity. Select AUTO and press [Enter]
and the AUTO BW submenu will appear to control the BW level. Depending on ON
or OFF, the BURST signal may output or no.
CAMERA ID OFF
IRIS ALC...
SHUTTER OFF
AGC ---
WHITE BAL ATW1
FOCUS MODE ONEAF
ALARM SET ... PRESS THE
COLOR/BW AUTO...
ENTER
PRIVACY ON...
BUTTON.
SPECIAL ...
PRESET ...
EXIT QUIT
- BURST ON : The color burst signal is output together with black and white composite
video signal.
- BURST OFF : The color burst signal is not output.
- LEVEL :You can set the brightness level that changes from COLOR mode to BW mode
in 3 steps : LOW, MEDIUM, and HIGH.
- DWELL TIME : Set the HOLDING time for switching between COLOR and BW mode
depending the changes in the amount of light.You can set the HOLDING
time to 10sec (S), 30sec, 60sec, or 300sec( L).
In AUTO mode, AGC will operates in high speed mode, and you cannot
change it manually, as it is indicated by "---".
E
(AUTO)
BURST ON
LEVEL LOW
DURATION S ---I--- L
RET
41