Agc/Motion; White Bal - Samsung SCC-C9302FP Bedienungsanleitung

CAMERA MENU Organization
The DIS feature is unavailable while setting the AUTO slow shutter.
If you set SHUTTER to between AUTO X4... and AUTO X128..., FOCUS mode will be
displayed as "MF"(the product can operate only in MF mode). You can't adjust the
settings manually.
If you set it to OFF, 1/100 ~1/10K or AUTO X2..., the product will recover the previous
FOCUS mode.
E
If you set SHUTTER to between AUTO X2 and AUTO X128, DIS will be displayed as
"---" (it can only operate in Off mode). You can 't adjust the settings manually. If you set
it to OFF or 1/100 ~1/10K, the product will recover the previous settings of DIS.

AGC/MOTION

In the AGC (Automatic Gain Control) option, you can specify whether to
automatically control the GAIN when the obtained video is below a certain level of
brightness because it was recorded under insufficient lighting. To automatically
control the GAIN, set the AGC option to LOW or HIGH. Otherwise, set it to OFF. If
the you set the AGC option to LOW, the maximum GAIN of the AGC will be set to
low, and if set to HIGH, the maximum GAIN will be set to high.
If the SHUTTER is in AUTO mode, AGC is switched to MOTION.
In MOTION, use the [left,right] key to select "S.SLOW / SLOW / NORMAL / FAST /
F.FAST".
CAMERA ID
IRIS
SHUTTER
AGC

WHITE BAL

FOCUS MODE
ALARM SET
COLOR/BW
PRIVACY
SPECIAL
PRESET
EXIT
34
ON...
ALC...
OFF
LOW
ATW1
ONEAF
...
COLOR...
ON...
...
...
QUIT
<AGC>
WHITE BAL
You can select one of four modes for white balance adjustment as follows:
- ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes, the color
temperature is monitored continuously and thereby white balance is set automatically.
The following are the approximate supported color temperature ranges in these modes.
ATW1 : 2500K ~ 9300K( * 1)
ATW2 : 2000K ~ 10000K(Mode recommended for sodium lighting)( * 2)
* 1. If the color temperature is out of this range in ATW1 mode,proper white balance may
not be obtained. In that case, select ATW2 mode.
* 2. In ATW2 mode, if one color is dominated in the shooted area, the color can be
displayed differently. Therefore, select the mode which is appropriate for the
environment.
- AWC(Auto-Tracing White Balance Control): In this mode, accurate white balance is
obtained by pressing [ENTER] while having a white paper in front of the camera. White
Balance data will be maintained after set it once. AWC mode is best in locations where
the color temperature of light source is constant.
- MANU : If WHITE BAL menu is set to MANU mode, the user can set the white Balance
considering the current illumination. Select MANU item and press [ENTER], the
sub screen where you can select Manual White Balance will be shown. Use the
left/right keys to select 3200K, 5600K or OFF(USER) mode in the PRESET
menu.
* 3200K : Set color temperature to 3200K
* 5600K : Set color temperature to 5600K
* USER : Choose out a proper value from the RED and BLUE graph for color and
temperature setup.
E
35