32 www.electrolux.com
2
1
WARNING!
Reposition, level the appliance,
wait for at least four hours and
then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
8. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
3
2
• Unscrew the lower hinge (1). Move the
pin to the opposite side (2).
• Unscrew and move the pedal to the op-
1
posite side (3).
• Unscrew (1) and move (2) the bracket
to the other side on the door.
• Screw on the lower hinge on the oppo-
site side.
• Tighten the pin with the adjustment
spanner supplied.
• Raise the appliance and install the ven-
tilation grill.
• Remove the covers on the handles
carefully with a small screwdriver.
• Unscrew the handle.
• On the opposite side remove the hole
covers by driving a 3–4 mm drift or drill
into them.
• Install the handle.
• Install the covers on the handle.
• Install the hole covers provided within
the accessory bag.
• Put the cabinet in position.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the nat-
ural fitting of the gasket.