Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16.2
Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
•
Before each operation, check the perfect condition of the safety devices.
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only proper and suitable tools.
•
•
Use only original spare parts recommended by the manufacturer.
16.2.1
Maintenance and servicing plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when using the machine within the specified limits:
Interval
Before every start of work
Each time after
completion of work
Weekly
As required
16.2.2
Changing the grinding wheel
16.2.3
Lubricate
16.2.4 Checking and cleaning the coolant system
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Component
Grinding disc
Power cord
Surfaces
Air vents
Slide way
Guide shaft
Grinding disc
Coolant system
•
Loosen the flange nut (1) counterclockwise
Remove flange nut (1), spring washer (2), flange (3) and
•
grinding wheel (4)
Clean the drive shaft (5), shaft flange and all parts thoroughly
•
•
Make sure that the new grinding wheel is undamaged and
not dirty.
Insert the new grinding wheel
•
Pull on the flange, spring washer and the flange nut
•
Tighten the flange nut
•
Lubricants are toxic and must not be released into the environment. When
changing, use suitable collecting containers with sufficient volume! Follow
the manufacturer's instructions and, if necessary, contact your local
authority for further information on proper disposal.
•
Lubricate grease nipples (1) of the guide shafts (2) with
machine oil
•
Lubricate the side way (3) with machine oil
Coolants are toxic and must not be released into the environment! Follow
the manufacturer's instructions and contact your local authority for
information on proper disposal if necessary.
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
What to do?
check for damage
remove dust and dirt
grease with machine oil
grease all grease nipples with machin oil
replace, dressing
check, clean, fill in
N O T E
N O T E
24
MS7000_230V
Werbung
