Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12.3
Safety devices
The machine is equipped with the following safety devices:
12.4
General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the
following points must be observed in addition to the general rules for safe working:
Check the machine for completeness and function before starting.
•
•
Select a level, vibration-free surface as the installation area.
•
Ensure sufficient space around the machine.
•
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
Ensure a clean working environment.
•
Keep the area around the machine free of obstacles (e.g. dust, chips, cut-off workpiece
parts, etc.).
•
Only use tools that are in perfect condition and free of cracks and other defects (e.g.
deformations).
Remove tool keys and other setting tools before switching on the machine.
•
Check the machine's connections for strength before each use.
•
Never leave the running machine unattended. Switch off the machine before leaving the
•
working area and secure it against unintentional or unauthorized restarting.
The machine may only be operated, maintained or repaired by persons who are familiar
•
and who have been informed about the dangers arising from this work.
•
Ensure that unauthorized persons keep a safety distance from the machine and keep
children away from the machine.
•
Always work with care and the necessary caution and never use excessive force.
•
Do not overload the machine.
•
Hide long hair under hair protection.
•
Wear close fitting protective work clothing and suitable protective equipment (eye
protection, ear protection).
Never wear loose jewellery, loose clothing or accessories (e.g. tie, scarf).
•
Do not work on the machine if you are tired, not concentrated or under the influence of
•
medication, alcohol or drugs!
Do not use the machine in areas where vapours of paints, solvents or flammable liquids
•
represent a potential danger (danger of fire or explosion!).
Shut down the machine and disconnect it from the power supply, before adjustment,
•
changeover, cleaning, maintenance or repair work, etc. Before starting work on the
machine, wait until all tools or machine parts have come to a complete standstill and
secure the machine against unintentional restart.
•
Warning signs and/or stickers on the machine that are illegible or have been removed must
be replaced immediately!
12.5
Electrical safety
•
Make sure that the machine is grounded.
Only use suitable extension cables.
•
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Protective device protection cover grinding disc (1)
SAFETY
19
MS7000_230V
Werbung
