Prophete GENIESSER Bedienungsanleitung Seite 165

TORQUE SPECIFICATIONS
DANGER OF DAMAGE AND ACCIDENTS!
• The screws and nuts installed on the bicycle must be checked for tight fit at regular
intervals (see maintenance plan) and may need to be tightened or re-tightened to the
proper strength. Only this can ensure that the bicycle permanently complies with the
DANGER
safety-technical requirements and works properly.
• If screw and nuts are tightened too far, they may break.
• If parts are marked with torque specifications, these must be complied with.
• The torque specifications for other screw connections do not apply to the adjustment
screws at the gearshift and brake components.
The torque wrench permits precise compliance with the tightening torques.
Wheel nuts, front (motor front)
Wheel nuts, rear (motor front + middle)
Wheel nuts, front (motor rear + middle)
Wheel nuts, rear (motor rear)
Thru axle
Foot pedal arm, steel
Foot pedal arm, aluminium
Pedals
Handlebar clamp block screw (M6)
Handlebar clamp block screw (4xM5)
Lateral clamping screws (A-head stem)
Angle adjusting screw (stem)
Stem Steerer Clamp (M8)
Brake shoe fixing
Brake disc fixing
Seatpost clamp ring
Saddle clamp
Damper / Shock
OTHER STEEL SCREWS
SIZE / STRENGTH CLASS
M3
M4
M5
M6
M8
50 Nm
25–30 Nm
25-30 Nm
50 Nm
10 Nm
30 Nm
30–35 Nm
30–35 Nm
10–14 Nm
6 Nm
9–11 Nm
18-30 Nm
20-30 Nm
5–7 Nm
5–7 Nm
8–12 Nm
18–22 Nm
10 Nm
5.6 6.8 8.8
0.7 Nm 0.9 Nm 1.2 Nm
1.7 Nm 2.1 Nm 2.8 Nm
3.4 Nm 4.3 Nm 5.5 Nm
5.9 Nm 7.3 Nm 9.6 Nm
14.3 Nm 17.8 Nm 23 Nm
TORQUE SPECIFICATIONS
OTHER VA SCREWS A2/A4
10.9 50 70
1.7 Nm - -
4.1 Nm - -
8.1 Nm 1.7 Nm 3.5 Nm
14 Nm 3 Nm 6 Nm
34 Nm 7.1 Nm 16 Nm
80
-
-
4.7 Nm
8 Nm
22 Nm
EN 77