Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When using an extension cable, make sure that the dimension matches the connected load of
•
the machine. The connection power can be found in the technical data, the correlation of cable
cross-section and cable lengths can be found in the technical literature or obtain information
from a specialist electrician.
•
A damaged cable must be replaced immediately.
14.3.1
Setting up a 400 V machine
The grounding conductor is yellow-green.
•
•
Connect the supply cable to the corresponding terminals in the input box (L1, L2, L3, N and PE),
see the figure below. If a CEE plug is available, the connection to the power supply is made
through an appropriately powered CEE coupling (L1, L2, L3, N and PE).
Plug connection 400V:
•
After the electrical connection, check the correct running direction. If the machine runs in the
wrong direction, swap two conductive phases, e.g. L1 and L2, at the connection plug.
Operation is only permitted with residual current device (RCD) with maximum
residual current of 30 mA.
15
OPERATION
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before adjustments,
cleaning, maintenance or repair work and secure it against unintentional
reconnection.
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices and operating elements must be
checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
Check that the saw blade is firmly seated before starting.
•
Check the running direction of the saw blade (direction of arrow!).
•
Never start the machine with the workpiece pressed down.
•
Always operate the machine with the extraction system switched on.
•
Always adjust the cutting speed to the respective workpiece (material, size).
•
Use the push stick to avoid the risk of contact with the saw blade.
•
Guide the workpiece evenly to the end of the cut without pulling it back.
•
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
5-wire:
with
N-conductor
N O TE
WAR N I N G
OPERATION
4-wire:
without
N-conductor
ZI-TS315-230 | TS315-400
29
Werbung
