Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Please note that locally applicable laws and regulations determine the minimum age of the operator
and may restrict the use of this machine!
Work on electrical components or equipment may only be carried out by a qualified electrician or
under the guidance and supervision of a qualified electrician.
Put on your personal protective equipment before working on the machine.
12.3
Safety devices
The machine is equipped with the following safety device:
12.4
General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the
following points must be observed in addition to the general rules for safe working:
Check the machine for completeness and function before starting. Only use the machine if
•
the separating and other non-separating protective devices required for machining have
are fitted.
Make sure that the guards are in good working order and properly maintained.
•
Select a level, vibration-free surface as the installation area.
•
Ensure sufficient space around the machine.
•
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
•
Ensure a clean working environment.
•
Keep the area around the machine free of obstacles (e.g. dust, chips, cut-off workpiece
parts, etc.).
Only use tools that are in perfect condition and free of cracks and other defects (e.g.
•
deformations).
•
Remove tool keys and other setting tools before switching on the machine.
•
Check the machine's connections for strength before each use.
•
Never leave the running machine unattended. Switch off the machine before leaving the
working area and secure it against unintentional or unauthorized restarting.
The machine may only be operated, maintained or repaired by persons who are familiar
•
and who have been informed about the dangers arising from this work.
Ensure that unauthorized persons keep a safety distance from the machine and keep
•
children away from the machine.
•
Always work with care and the necessary caution and never use excessive force.
Do not overload the machine.
•
Hide long hair under hair protection.
•
Wear close fitting protective work clothing and suitable protective equipment (eye
•
protection, face protection, ear protection).
•
Never wear loose jewellery, loose clothing or accessories (e.g. tie, scarf).
•
Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
Push stick (1): For feeding/pushing workpieces where
•
less than 120 mm is cut off.
Riving knife (2): This is intended to prevent the
•
workpiece from wedging.
Saw blade guard (3): Adjustable guard to prevent
•
contact with the saw blade.
Rip fence (4): For precise guidance of workpieces that
•
are cut lengthwise.
SAFETY
23
ZI-TS315-230 | TS315-400
Werbung
