Scheppach HC51V Originalbetriebsanleitung Seite 28

12.2 Maintaining the pressure vessel (fig. 3)
m Attention! To ensure a long service life for the pres-
sure vessel (2), drain off the condensate after each use
by opening the drain screw (1).
Release the vessel pressure beforehand (see 12.4.1).
The drain screw is opened by turning it counterclock-
wise (when looking at the screw on the bottom of the
compressor) so that the condensate can be completely
drained out of the pressure vessel.
Then close the drain screw again (turn clockwise).
Check the pressure vessel for rust and damage each
time before use.
The compressor shall not be operated if the pressure
vessel is damaged or rusty. If you discover damage,
please contact the customer service workshop.
12.3 Safety valve (fig. 1/10)
The safety valve (10) has been set for the highest per-
mitted pressure of the pressure vessel. It is not per-
mitted to adjust the safety valve or remove the con-
nection lock (10.2) between the exhaust nut (10.1) and
its cap (10.3).
Actuate the safety valve every 30 operating hours but
at least 3 times a year to ensure that it works when
required. Turn the perforated exhaust nut (10.1) coun-
terclockwise to open it and use your hands to pull the
valve rod outwards over the perforated exhaust nut
(10.1) to open the outlet of the safety valve.
Now, the valve audibly releases air. Then turn the drain
nut clockwise again to tighten.
12.4 Storage
m Attention!
Pull out the mains plug and ventilate the equip-
ment and all connected pneumatic tools. Store the
compressor in such a way that it cannot be used
by unauthorised persons.
m Attention!
Store the compressor only in a dry location which
is not accessible to unauthorised persons. Always
store upright, never tilted!
28 | GB
12.4.1 Releasing overpressure
Release overpressure in the compressor by switching
off the compressor and using up the compressed air
still in the pressure vessel, e.g. with a compressed air
tool running at idle or with an air blow gun.
12.5 Transport (fig. 1)
The compressor can be tilted it up by means of the
handle so that it can be transported on the wheels.
12.6 Ordering spare parts
Please provide the following information when ordering
spare parts;
• Device type
• Device article number
12.7 Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: clutch
* May not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
13. Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be
removed non-destructively before disposal. Their
disposal is regulated by the battery law.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.