Werbung
EN
•
There is adequate flow of air from outside the cabinet to the base of the hob.
•
If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
•
The isolating switch is easily accessible by the customer.
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.
Locating the fixing brackets
Fix the brackets on the left side and right side by screw. Put the induction hob in the
cut-out cabinet.
hob
bracket
Cautions
•
The hob must be installed by qualified personnel or technicians, we have
professionals at your service. Please never conduct the operation by yourself.
•
Do not mount the hob above cooling equipment, dishwashers and tumble dryers.
•
The hob shall be installed such that better heat radiation can be ensured to
enhance its reliability.
•
The wall and induced heating zone above the work surface shall withstand heat.
•
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
•
A steam cleaner is not to be used.
•
This hob can be connected only to a supply with system impedance no more
than 0.427 ohms. If necessary, please consult your supply authority for system
impedance information.
Assembly of the oven
•
The door and/or handle must not be used for lifting or moving the appliance.
•
For installation the appliance must be connected in accordance with electrical
regulations.
•
Carry the appliance with at least two persons.
•
Use the slots or wire handles located at both sides to move the appliance.
•
Make an opening with the dimensions given in the diagram for the oven to befitted.
•
Make sure the mains plug is disconnected and then connect the oven to the mains
supply.
•
Partially insert the oven into the prepared opening and connect the oven to the
14
table
hob
bracket
table
Werbung
