Werbung
board
A(mm)
B(mm)
760
50 mini
Before you install the hob, make sure that
•
The work surface is square and level, and no structural members interfere with
space requirements.
•
The work surface is made of a heat-resistant material.
•
If the hob is installed above an oven, the oven has a built-in cooling fan.
•
The installation will comply with all clearance requirements and applicable
standards and regulations.
•
A suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to comply
with the local wiring rules and regulations.
•
The isolating switch must be of an approved type and provide a 3-mm air gap
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
•
The isolating switch will be easily accessible to the customer with the hob installed.
•
You consult local building authorities and by-laws if in doubt regarding installation.
•
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
•
Lower part of induction cooker ambry must install the product such as oven,or
close with board.
When you have installed the hob, make sure that
•
The power supply cable is not accessible through cupboard doors or drawers.
C(mm)
D
20 mini
Air intake
product
E
Air exit 5mm
EN
13
Werbung
