Weak Batteries - HomeMatic HM-RC-8 Bedienungsanleitung

Errors and information indicated by the device LED
1 s lighting up All actuators
green have confirmed
the (most recent)
bidirectional com-
mand.
2 s lighting At least one
up red actuator has not
confirmed the
(most recent)
bidirectional com-
mand.
1 x red, green LED test display
and orange
flash
Teaching-in and restoring factory settings
Flashing code Meaning
Slow green Configuration
flashing mode (device
waiting for radio
signal)
Slow orange Teach-in mode
flashing (device waiting for
wireless partner)
Fast orange Configuration or
flashing teach-in mode
(data being
received)
48
You can continue
with operation.
Please try again.
Once the test dis-
play has stopped,
you can continue.
Solution
Wait until the
configuration data
has been sent.
Switch the device
to be taught-in to
teach-in mode.
Wait until the pro-
cess is completed.
Errors and information indicated by the device LED
1 s lighting up Teach-in suc-
green cessful
2 s lighting Teach-in failed
up red
Slow green Remote control
flashing and has already been
red light if but- taught-in to a
ton is pressed central control unit
and is therefore
blocked for direct
teach-in
Slow red Stage before
flashing resetting to factory
settings
Fast red Teach-in button
flashing has been pressed
long to perform
factory reset

7.2 Weak batteries

Provided that the voltage value permits it, the remote
control will remain ready for operation also if the battery
voltage is low. Depending on the particular load, it may
be possible to send transmissions again repeatedly, once
You can continue
with operation.
Try again.
see „5.2.1
Teaching-in directly
in to HomeMatic
devices" on page
39
Device is waiting
for teach-in button
to be pressed and
held in order to
carry out a reset, or
for a short button
press to cancel the
process.
Factory settings are
restored if teach-in
button is released
49