Teaching-In To A Homematic Central Control Unit Your Device Can Be Conveniently - HomeMatic HM-RC-8 Bedienungsanleitung

Start-up
• The remote control is now in configuration mode.
The device LED flashes green to indicate this. (To
exit configuration mode, briefly press the teach-in
button again.)
• To enter teach-in mode, press the remote control
button in to which you wish to teach a function. The
device LED flashes orange slowly. (Provided the
device to be taught-in is not yet in teach-in mode,
you can cancel teach-in mode on the remote control
by pressing the teach-in button again briefly. The
device LED then lights up red.)
• Now put the device in to which you wish to teach the
remote control into teach-in mode by following the
relevant operating manual instructions.
• If both devices are in teach-in mode, the LED flash-
es orange quickly to indicate this.
The device LED lights up green to indicate that teach-
ing-in has been successful.
40
If the device LED lights up red for 2 seconds, teaching-
in the device failed. In this case, please try again.
If no teach-in operations are carried out, teach-
in mode is exited automatically after 20 sec-
onds.
If the remote control has already been taught-in
to a central control unit, it is blocked for direct
teach-in to other devices and the device LED
lights up red for 2 seconds.
5.2.2 Teaching-in to a HomeMatic Central Control Unit
Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in central control unit programs
by using the HomeMatic software "WebUI". Therefore,
your remote control has to be taught-in to the Home-
Matic Central Control Unit first. New devices are taught-
in to the central control unit via the HomeMatic „WebUI".
A soon as a component has been taught-in to a
central control unit, it can only be connected to
other components via this unit.
Each component can only be taught-in to one
CCU.
Start-up
41