Start-Up; Inserting And Replacing Batteries; Changing Batteries - HomeMatic HM-RC-8 Bedienungsanleitung

Start-up

5 Start-up

5.1 Inserting and replacing batteries

5.1.1 Inserting batteries
To start up the device, please insert the batteries. To do
this, proceed as follows:
• Open the battery compartment on the rear (H) by
pressing the release button (F) with you finger (1.)
and moving the cover of the remote control to the
back (2.).
F
1.
2.
• This will open the catch; you can then remove the
cover (3.).
36
3.
• Place two LR03/AAA/micro batteries into the bat-
tery compartment, using the polarity markings to
ensure the polarity is correct.
• Close the battery compartment by replacing the
cover and pushing it with light pressure to the end
of the housing until it latches into place.

5.1.2 Changing batteries

If you press a button on the remote control and the flash-
ing code indicating empty batteries is displayed (5 x red
flashes), or the device being controlled does not re-
spond, replace the used batteries with two new LR03/
AAA/micro batteries, as described in the previous sec-
tion. You must observe the correct battery polarity.
Never recharge standard batteries. Do not
throw the batteries into a fire. Do not expose
batteries to excessive heat. Do not short-circuit
batteries. Doing so will present a risk of explo-
sion.
Start-up
37