MPM MOD-22 Bedienungsanleitung Seite 33

USING THE APPLIANCE
To ensure the highest comfort and safety a vacuum cleaner has been equipped with a
water filter. It is a specially designed device whose role is to absorb the tiniest particles of
dust and dust mites with the use of physical properties of water. Principle of water filter
operation is that the air sucked into the vacuum cleaner goes through a water container,
leaving all dust and dust mites in it.
DRY CLEANING (WITH WATER FILTER HEAD)
1. Make sure that the device is disconnected from mains.
2. Disengage the clamps (D6) and lift an engine's set using a handle.
3. Take a water filter element (B2) off (PIC. 2.10) and fill it with clean water (max. 2l).
4. Put a water filter element (B2).
5. Put an engine's set back on the device and lock the clamps.
6. Connect a sucking hose (E5) (PIC. 2.5), using a fixing element (E1) to sucking inlet of the vacuum
cleaner (B8).
7. Additional accessories can be connected to sucking tube (E9) or directly to a handle (E8) depending
on what you are going to do.
8. Connect the device to the mains.
9. Use a switch (A2) to switch a vacuum cleaner on.
10. If the vacuum cleaner sucks in a substance that will foam the water in the water filter, immediately
turn off the vacuum cleaner, unplug the power cord and add 2 or 3 drops of the defoamer (H4) to
the water in the water bin. Resume vacuuming. If foaming persists, change the water in the water
bin.
CAUTION! For a fresh scent in the vacuumed room, sprinkle the HEPA 13 filter with a little air freshener (H2).
WARNING! If liquid container is empty or if you do not use washing or wet cleaning function, do
not use the pomp.
WARNING! Do not ever vacuum wet floors with your vacuum cleaner (in dry cleanning mode)
Using the equipment described above you can clean:
Floor and carpet head (H1) – used to remove dust from carpets, rugs and hard
-
floor surfaces. It is equipped with rings allowing easier handling and a button.
After pressing the button you can adjust the head for hoovering hard surfaces,
for example floors, parquets.
Narrow attachment (H5) – used to clean places that are not easily accessible.
-
Turbo brush (H6) – for cleaning carpets, fitted carpets.
-
integrated brush (H7) - thanks to its position on the suction pipe, it is instantly
-
accessible and saves time. To use it, remove the current equipment from the end
of the tube and rotate the brush 180° until the lock engages.
CAUTION! To disconnect the suction pipes and equipment, press the pipe lock button (E4) located on the
suction pipe and/or handle.
WET WASHING AND CLEANING
1. Make sure that the device is disconnected from mains.
2. Lift an engine's set above the container. Make sure that a filter (A8) is mounted.
3. Lift water filter element (B2) and container (B1).
4. Remove the water filter tube (B4), as its presence during wet vacuuming can cause foaming. Put
the rubber stoppers (B9) on the tabs with holes, on the lower part of the water body (B2) fig.18.
EN
33